Frame

1- Use 1m Alu profile with cross section of 15*15mm .

2- Cut it to two pieces (2* 0.5 m).

3- Make a cut in the middle of them as it shows in the picture.

4- Put them together by using two pieces of fibreglass (4mm) and 4 screws ( 25mm* 3mm)

5- Mount 4 screws (75mm*3mm) on upper fibreglass for creating and structure to mounting electronic later.

6 - Use a cloth hang like the one it shows in the picture for the legs. Dismantle it to get arms out of it.

7- Drill two holes on the frame as it shows to mount the legs.

8- Mount the legs with using one 20mm*3mm screw.

9- Drill holes on the frames for mounting the engins as it shows

10- Tight engines to the frame by two screws. Use the plate which normally comes with the engines

between engine and frame. It helps to keep the engine straight in position.

<Back>